feat: add M95M02-only GAS and EEPROM profiles

Expose the existing registers through Modbus and service CAN using one GAS provider only in M95M02 builds.
Include the EEPROM layout/driver, LOAD protection and calibration, firmware identity and shared CCS build workflow.
Add transport/profile and SCI8 validation tests, documentation and the checked M95M02 firmware image.

Source/Internal/main.c

@@ -39,8 +39,6 @@ void main()
 {
   int i,j,mask;
   static unsigned int cancount[2], cancell[2], rscount;
-  static int preCstart=1,preCstop=1;
-  int umpstart,umpstop;
   RS_DATA * rs;
   int presbyt=0;
 
@@ -83,6 +81,7 @@ void main()
 
 	clear_mem();
 	ump_log_init();
+    Load_control_init(); /* Explicit initialization before IRQ. */
 	set_cntrl_addr(Mode,16);
 	timer_Init();
 	EnableInterrupts();
@@ -178,27 +177,8 @@ void main()
 			presbyt = bTermoCal;
 		}
 
-		if(Desk==dsk_LOAD)
-		{
-		    umpstart = cUMPstart;
-		    umpstop = cUMPreset;
-
-			if(umpstart & !preCstart)
-			{
-				set_START_DPTB();	set_RES_OUT_2(); 
-				IMPowse = READY_FREQ;
-			}
-			preCstart = umpstart;
-
-			if(umpstop & !preCstop)
-			{	
-				set_STOP_DPTB();	clear_RES_OUT_2();
-				IMPowse = READY_FREQ; 
-			}
-			preCstop = umpstop;
-
-			if(!IMPowse) { clear_START_DPTB(); clear_STOP_DPTB(); }
-		}
+        /* Timer1 owns START/STOP/permission and the DAC ramp together.
+         * Main must not re-enable the output during a protected reload. */
 
 		/* Ñíèìîê ïîñëå îáíîâëåíèÿ âõîäîâ è ôîðìèðîâàíèÿ ïóñêîâûõ âûõîäîâ. */
 		ump_log_io();