feat: add M95M02-only GAS and EEPROM profiles

Expose the existing registers through Modbus and service CAN using one GAS provider only in M95M02 builds.
Include the EEPROM layout/driver, LOAD protection and calibration, firmware identity and shared CCS build workflow.
Add transport/profile and SCI8 validation tests, documentation and the checked M95M02 firmware image.

F28335.cmd

@@ -69,6 +69,18 @@
  */
 
 
+/* Serial EEPROM is NOT CPU-addressable RAM/Flash. Do not add a fake MEMORY
+ * region at address zero: SPI boot copies its table into the RAM areas below.
+ * Export its physical layout as absolute byte/word symbols for .map/debugging.
+ * The final SCI8 image size (including boot headers) is checked after hex2000. */
+#include "Source/Internal/Include/eeprom_config.h"
+#include "include/balsam167_eeprom_layout.h"
+_EEPROM_TOTAL_BYTES = BALSAM167_EEPROM_BYTES;
+_EEPROM_FIRMWARE_LIMIT_BYTES = BALSAM167_EEPROM_FIRMWARE_BYTES;
+_EEPROM_PARAMS_START_WORD = BALSAM167_EEPROM_PARAMS_START_WORD;
+_EEPROM_PARAMS_START_BYTE = BALSAM167_EEPROM_FIRMWARE_BYTES;
+_EEPROM_PARAMS_END_BYTE = BALSAM167_EEPROM_PARAMS_END_WORD * 2;
+
 MEMORY
 {
 PAGE 0:    /* Program Memory */